Professionalism Based on Methodical Work

The Wetrok cleaning methodology ensures that cleaning processes are worked off in the correct sequence and using the right machines and products for optimised results.


Removal of loose dirt Removal of adhering dirt Protective treatment Cleaning surfaces above the ground

Dry and wet sanding

Medium area performance: 50 m2/h

Mechanical removal of covering material from hard coverings using abrasive substances.
This improves surfaces. Surfaces may change!

Choose the right abrasive material for the floor covering (abrasive paper, mesh, pads, diamond abrasive wheel, etc.).

Dry and wet sanding
Preparatory work

Equip and prepare the machine.
Follow the operating instructions.

Remove any loose dirt.
Dusting
Dry/brush vacuum cleaning

Put up the warning sign.

Main work involved A) Dry sanding

Sand the floor covering one strip at at time, working in circles.

Sand corners and edges manually or using a machine.
Use the edge cleaning tool/BrushBoy.

B) Nassschleifen

Sand the floor covering one strip at at time, working in circles and adding water as you go. Work your way towards the outlet (jack).

Sand corners and edges manually or using a machine.
Use the edge cleaning tool/BrushBoy.

Use a wet vacuum cleaner or scrubberdrier to suck up the dirty water.
Wet vacuuming
Scrub drying

Final steps

For wet sanding only: Leave the floor to dry out completely.

Check and clean cable.

Empty the tank, wipe the machine down with a damp cloth, and clean the cleaning materials if necessary.
Wash the pad/brush or replace if necessary.